Est.

ADS-B Integration in Digital Tower Surveillance Systems

ADS-B ground stations can give small airports surveillance at a fraction of radar's cost.

· 8 min read
Cover illustration for “ADS-B Integration in Digital Tower Surveillance Systems”
Digital Tower Technology · October 29, 2026 · 8 min read · 1,822 words

ADS-B integration transforms a digital tower from a camera system into a surveillance platform by combining aircraft identity and position with visual and other sensor feeds. At non-towered airports, this layered architecture provides the ground traffic picture needed to support UAS integration. It is not a complete drone-detection system, because most small drones do not broadcast ADS-B and require other surveillance inputs.

Why most U.S. airports have no surveillance picture at all

Most U.S. airports without control towers also have no surveillance infrastructure. Pilots and ground personnel therefore have no shared, authoritative picture of aircraft positions. The Air Traffic Situational Awareness Enhancement Act’s bill announcement states that more than 90 of the 527 U.S. airports with towers lack radar or other modern situational awareness technology. That count excludes thousands of non-towered airports entirely. The shortfall extends well beyond facilities with controllers.

At non-towered airports, separation depends on pilot self-announcement over radio and see-and-avoid. Those practices were built for lower traffic densities than many of these airports now handle. A radio announcement communicates a pilot’s reported position and intentions, but it does not provide a surveillance display. Each pilot must piece together the nearby traffic from radio calls and what they can see. What is absent is a common picture that places those aircraft together, rather than leaving each participant to interpret separate reports.

What ADS-B actually transmits and why that matters for ground surveillance

Automatic Dependent Surveillance–Broadcast, or ADS-B, continuously broadcasts GPS-derived aircraft information without requiring interrogation from a ground station. “Automatic” means that transmission requires no pilot input, while “dependent” means that the information comes from the aircraft’s own navigation system. The broadcast supplies identification, position, altitude, and movement information. A suitably equipped ground receiver can use it directly. Unlike radar, the receiver does not need rotating antenna infrastructure to establish where an equipped aircraft reports itself to be.

ADS-B uses two datalink frequencies, which are 1090 MHz and 978 MHz. The former is universal and used by commercial and most GA aircraft, while the latter supports broadcasts from aircraft operating exclusively below the flight level separating lower-altitude operations from upper airspace. A ground station at a small airport must receive both.

The distinction between ADS-B Out and ADS-B In explains the infrastructure gap. ADS-B Out is the aircraft broadcast and has been mandatory for most U.S. aircraft since January 2020, while ADS-B In receives and displays that information. Equipping the aircraft alone does not give people on the ground a traffic picture. Under normal GNSS conditions, ADS-B position is generally more accurate than secondary surveillance radar position, making it a high-quality input available at a fraction of radar’s cost. That advantage remains dependent on the aircraft’s navigation data.

How a digital tower receives, fuses, and displays that ADS-B data

The FAA defines a digital tower as a system providing ATCT services through cameras, sensors, displays, and support equipment, with controllers working through dedicated digital displays. It changed its terminology from “Remote Tower” to “Digital Tower” to emphasize the technology and remove the implication that the facility must be off-airport. Location is therefore a separate design choice. A digital tower can be co-located with the airport or operated from a centralized facility.

Surveillance starts when a receiver on the ground picks up aircraft broadcasts. ADS-B supplies the identification and precise position layer that cameras cannot provide by themselves. A camera shows that an object is present. The broadcast adds which equipped aircraft it is, where it is, and how fast it is moving. Receiving the broadcasts, however, gives the operator another source of data that still needs to be joined with the other inputs.

Fusion turns those separate inputs into one display. The system ingests ADS-B and other sensor streams together, correlating aircraft information with the camera view. The controller then sees broadcast-derived label tags superimposed on that view, showing callsign, altitude, and track for equipped aircraft. This is the architectural distinction between surveillance and video. The display connects an aircraft’s visible presence to its reported identity and movement rather than requiring the controller to reconcile separate screens.

Research at Braunschweig-Wolfsburg Airport tested this augmented-reality concept in a prototype that placed ADS-B aircraft labels directly onto the out-the-window camera view. Nine of ten expert controllers strongly recommended the concept, and it scored high on the System Usability Scale in good and low-visibility conditions. The result supports the presentation method’s usability. It does not establish that the prototype is deployed operational practice.

An Airborne Position Reference Tool, or APRT, offers a simpler bridge from no surveillance to a displayed aircraft picture. It receives ADS-B through ground infrastructure and/or cloud processing and presents aircraft positions on a controller screen without radar. uAvionix received FAA approval in 2025 for the first APRT system, its cloud-based FlightLine solution. An APRT provides the position-display layer without necessarily combining that layer with camera imagery and other sensors.

Why non-towered airports are the natural home for ADS-B-based surveillance

Traditional radar needs a lot of physical infrastructure, takes a long time to buy and install, and needs ongoing maintenance. Those demands are structurally incompatible with many small-airport budgets. ADS-B ground stations have a different deployment footprint. They are compact, can mount on existing structures, and connect through IP networks, while software-defined reception and cloud-deliverable data reduce dependence on large local installations. Their footprint is a fraction of radar’s.

The aircraft-side investment is also largely behind these airports. Following the 2020 mandate, most GA aircraft already transmit ADS-B Out, so a new ground receiver can obtain equipped traffic positions without coordinating a new installation with each aircraft operator. The remaining work is on the ground side. Near-universal equipage has not been matched by a systematic extension of reception and display infrastructure to smaller airports.

ADS-B-enabled digital infrastructure can be deployed for a fraction of the cost of constructing a traditional staffed tower. The FCT Competitive Grant Program’s FY2026 Notice of Funding Opportunity expressly includes construction of FAA-certified remote towers and acquisition and installation of ATC, communications, and related equipment at full federal cost share. Growing UAS activity strengthens the operational case, because additional low-altitude traffic increases the value of a ground picture even though ADS-B cannot show every drone.

What the safety record at non-towered airports says about the cost of doing nothing

The safety liability is the concentration of separation responsibility in individual pilots without a controller holding a common traffic picture. Self-announcement and see-and-avoid become less effective as traffic density, speed differences, and weather variability increase. Conflicting aircraft can converge without anyone being aware of both simultaneously. This is the central surveillance failure. The case for improvement requires recognizing the limits of operating without a ground picture.

Drone activity introduces an important qualification to that case. Most small drones are not ADS-B Out–equipped, so they remain absent from an ADS-B display even where ground reception exists. Low-altitude airspace around smaller airports is particularly exposed to this limitation because drone operations concentrate there. ADS-B alone cannot resolve that detection gap. ADS-B can show equipped aircraft in the same airspace, but a mixed-traffic picture needs inputs from other sensors because every aircraft cannot be assumed to broadcast.

Staffing creates a related gap at airports that do have towers. When staff shortages cut tower coverage hours, the airport is open for longer than the tower. Digital systems can support nighttime or backup coverage, including at existing Class D facilities. That capability depends on the operating arrangement. Moving from no surveillance to a fused ADS-B picture is a categorical improvement in available traffic information, while incomplete equipage and controller availability remain constraints that the system must address.

Where the technology stands globally and what U.S. deployment has yet to catch up to

London City Airport shows digital tower services at work at a major commercial airport, where controllers manage traffic from 115 km away. Physical co-location is not a prerequisite for tower operations. European deployments also demonstrate workforce benefits from digital environments serving multiple airports. These environments have drawn younger recruits, and better situational awareness cuts controllers’ workload and stress. Those results matter for U.S. staffing pressures, though they give no grounds to copy any particular European operating model.

The domestic constraint is federal implementation. The FAA states that additional work is necessary before digital tower systems can be deployed at federally owned ATCTs. Certification and implementation requirements serve legitimate operational purposes. However, the existence of functioning systems abroad distinguishes those requirements from a claim that the underlying technology is still experimental.

Investment also faces the cost of sustaining two surveillance types. Although ADS-B could in theory replace aging radar systems, the FAA must now pay to support both, leaving less money for new ground infrastructure at smaller airports. Modernization therefore involves more than procuring a receiver. The U.S. formally concluded the NextGen Office on December 31, 2025, transferring unfinished programs to a new Airspace Modernization Office under an Info-Centric NAS framework. That framework provides a policy vehicle for extending information-based infrastructure to airports still outside the surveillance network.

What a well-integrated ADS-B digital tower system looks like in practice for a small airport operator

For a small airport operator, evaluation begins with the distinction between a position display and a full digital tower. An APRT provides broadcast-derived aircraft positions, while the full tower combines those positions with visual and other sensor information to support ATCT services. The categories serve different operational needs. A deployable system therefore involves reception, connectivity, display integration, and staffing. Its value depends on how those components fit existing airport operations.

The physical installation can use receivers mounted on existing structures and cameras positioned for full angular coverage without constructing a conventional tower. An IP network connects those inputs to an on-airport or centralized workstation. The staffing model can also change. Controllers can serve multiple airports from a centralized facility, reducing the physical staffing constraints that make traditional towers impractical for some small airports. Centralization determines where controllers work, while the way the surveillance system is built determines what information reaches them.

At the workstation, the integrated picture combines a 360-degree camera view with labels showing callsign, altitude, and track for equipped aircraft. Infrared feeds help when visibility is low, and surface movement data is available where the system includes surface radar or multilateration. Each layer has a distinct role. Aircraft without ADS-B Out do not appear in the broadcast layer, so camera imagery provides visual detection of non-equipped traffic. Sensor fusion is the complete architectural approach, although it does not make every target detectable under every condition.

For nearby UAS operations, the practical answer is layered surveillance rather than a display based only on aircraft broadcasts. Over time, drone receiver arrays or remote ID systems can be added to the ground infrastructure, so the investment can serve more than equipped manned aircraft. That capability is an integration path. The grant program provides the primary financial route identified for eligible operators considering certified tower construction and ATC equipment.

Sources

  1. Presenting ADS-B Labels in a Conventional and in a Remote Virtual Tower Environment: Beneficial or Disruptive?<!-- -->

More in Digital Tower Technology